"Getting the power supply freed from the packaging shows a gun metal grey powder coated finish on the case, with black sleeved main lines. The finish is done well, and even after a few screwdriver bites while removing the cover, there were no scratches to be seen in the powder coat finish. This is a big plus of powder coating over painting. The inlet side of the power supply is completely vented to promote airflow. Along the bottom of the power supply front are the 5 plugs for the component cables. All cabling is justified to the right to enable better cable routing against the back side of your case. Around back is the 80mm low speed ADDA fan that varies speed in response to load and temp conditions. The specification sticker graces the left side of the power supply showing the max current on each of the rails. Antec uses three +12V lines rated at 19A each to balance the current draw."