Reviews 51923 Published by

ipKonfig.com reviews the Maze3 water block from DangerDen,



The kit produced some very interesting scores on an Athlon 2800+ with 1.85v.

The products we're using are a bit on the extremist side. The pump is one that pushes quite a bit of water, and was recommended for the radiator we're using. As mentioned, the radiator can support 4 120mm fans. In our setup, we have two pushing and two pulling air through the radiator fins. This almost guarantees maximum cooling, and because the radiator measures in at 10.75 x 5.25 x 1.77 inches, a strong pump is needed. The inner copper core uses 9.44 inches of 2-pass double row flat tubes.

Installing this radiator can be a troublesome battle for small cases. It's huge, folks, and it is stressed that this unit be firmly mounted. The case we're using is very wide, tall, and has pre-cut 120mm fan holes on the rear of the case. This allowed us to install all four 120mm fans for optimal performance. Note that you will have a large radiator with two 120mm fans sticking out the rear. This is made possible by pre-drill holes found on both sides of the radiator's frame, making installation easier--provided you have the room in the first place.
Read more