Diamond Viper v550
This is a discussion about Diamond Viper v550 in the Windows Hardware category; Ok. . . Running Win2k now. . . but when I run DXDiag I get an error during Hardware D3D test. Direct3D test results: Failure at step 18 (CreateDevice): HRESULT = 0x80004002 (No interface) Do I have to install new drivers? Thanks.
Ok... Running Win2k now... but when I run DXDiag I get an error during Hardware D3D test.
Direct3D test results: Failure at step 18 (CreateDevice): HRESULT = 0x80004002 (No interface)
Do I have to install new drivers?
Thanks...
Direct3D test results: Failure at step 18 (CreateDevice): HRESULT = 0x80004002 (No interface)
Do I have to install new drivers?
Thanks...
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Dec 22
Dec 22
0
1 minute
Responses to this topic
What OS build?
What driver revision?
What overclocking - CPU and vid-card?
What driver revision?
What overclocking - CPU and vid-card?
OP
Win2k RC3
the driver that came with win
The video card is at 200 mhz I think
the driver that came with win
The video card is at 200 mhz I think
Go to http://win2kbox.8m.com and get the latest TNT drivers.
Also, don't overclock the vid-card while etsting, and don't o/c the CPU to anything unusual (115Mhz, etc) as this will also o/c the PCI and AGP bus (on most mobos) which causes BIG problems.
Also, don't overclock the vid-card while etsting, and don't o/c the CPU to anything unusual (115Mhz, etc) as this will also o/c the PCI and AGP bus (on most mobos) which causes BIG problems.
OP
Thanks... Gonna go see how it works....
