Diamond Viper v550 Drivers
This is a discussion about Diamond Viper v550 Drivers in the Windows Hardware category; I have 3. 76 drivers installed and OpenGL doesn't seem to work. Games like Quake 3 won't run. D3D runs fine and OpenGL use to work before I decided to update to higher drivers. After I went back to 3.
I have 3.76 drivers installed and OpenGL doesn't seem to work. Games like Quake 3 won't run. D3D runs fine and OpenGL use to work before I decided to update to higher drivers. After I went back to 3.76 it stopped working. Does anyone have any suggestions?
My system:
450mhz PII
Diamond Viper v550 16 Meg
256 Ram
SCSI HD, CD, CDR
My system:
450mhz PII
Diamond Viper v550 16 Meg
256 Ram
SCSI HD, CD, CDR
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Jul 13
Aug 9
0
1 minute
Responses to this topic
About a month or so ago (probably more)I popped my old DV550 into my computer to compare it to my Matrox G400. I used the 5.13 drivers Quake 3 & UT ran fine.
OP
The problem is though when i go to upgrade the drivers it does not recognize the 5.13 ini as a good one for the vid card... actually it doesn't recognize any of the drivers as good... it only shows the ones in the WinNT/Ini folder... I can't seem to understand why...
I had a vipe 550 before I got my geforce2 and I have used all the reference drivers that have been out. The best way to do it is pick the driver yourself, then use the have disk option. You will probably get a message that says windows cannot determine if the drivers is correct for your card. As lond as you picked the tnt driver, just ignore it and install it anyways.
Hi!
IΒ΄ve also this problems with the V550-driver. Where can I get a driver?
Heino
IΒ΄ve also this problems with the V550-driver. Where can I get a driver?
Heino
