G400, Win2k, Q3a, and a stick.
This is a discussion about G400, Win2k, Q3a, and a stick. in the Windows Games category; I downloaded the newest Matrox drivers for the G400 in 2000. Q3 loads and starts playing, but locks up after no more than 10 second of play. Help. .
I downloaded the newest Matrox drivers for the G400 in 2000. Q3 loads and starts playing, but locks up after no more than 10 second of play. Help.
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Dec 28
Dec 31
0
2 minutes
Responses to this topic
Not much help I know, but I get exactly the same problem running Unreal Tournament (W2K/Build 2195 & Matrox G400 drivers for W2K v5.00.07). It only locks up when running full screen though, works fine in a window. Appears to be something in the G400 drivers ?
I run W2K on a Dual Celeron/BP6 board, you running single or multi-processor ?
I run W2K on a Dual Celeron/BP6 board, you running single or multi-processor ?
OP
Well, my main machine is a BP6 with a 333 and 366 Celeron running at 110 bus ... so a 550 and 600. Nice board... in't it?
But the machine with the G400 (the other has a Tnt2u) is a Tyan Trinity (Via 133a chipset)(This board badly needs a bios update, but it has AGP4x and Ata66 as well as 133 for when I get a P3 later). That really shouldn't matter, though.
But the machine with the G400 (the other has a Tnt2u) is a Tyan Trinity (Via 133a chipset)(This board badly needs a bios update, but it has AGP4x and Ata66 as well as 133 for when I get a P3 later). That really shouldn't matter, though.
Yep, like the BP6 a lot, especially with W2K 
Running 2x466MHz Celerons (not overclocked at the moment, but I've tested them both up to 580Mhz without problems)
I'm keeping an eye out for some new Matrox W2K drivers as the only likely fix for this though :-(
Running 2x466MHz Celerons (not overclocked at the moment, but I've tested them both up to 580Mhz without problems) I'm keeping an eye out for some new Matrox W2K drivers as the only likely fix for this though :-(
I don't have a G400, I have a Banshee but I did experience the same problem with Unreal Tournament (it played in a window not full screen). I found out it was becuase the hardware acceleration (in my case Glide in your case D3d) was not running. The window game you get is software mode. You need to enable the OpenGL or D3d for your card (I haven't found a D3d driver for my card yet, hopefully you can find one for yours).
