Can´t get DMA with my cd-rom and burner
This is a discussion about Can´t get DMA with my cd-rom and burner in the Windows Hardware category; They work fine with win98 in DMA mode. Now win2k autodetects pio mode, and if I select use DMA if available the system reboots and hangs. I must use the repair setup. Using a Gigabyte 7IX mobo (AMD Irongate).
They work fine with win98 in DMA mode. Now win2k autodetects pio mode, and if I select "use DMA if available" the system reboots and hangs. I must use the repair setup.
Using a Gigabyte 7IX mobo (AMD Irongate).
Any ideas?
Thanks.
Using a Gigabyte 7IX mobo (AMD Irongate).
Any ideas?
Thanks.
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Aug 25
Aug 25
0
1 minute
Responses to this topic
Quote:Originally posted by Nuno:
They work fine with win98 in DMA mode. Now win2k autodetects pio mode, and if I select "use DMA if available" the system reboots and hangs. I must use the repair setup.
Using a Gigabyte 7IX mobo (AMD Irongate).
Any ideas?
Thanks.
Try to get a new IDE drivers for w2k
They work fine with win98 in DMA mode. Now win2k autodetects pio mode, and if I select "use DMA if available" the system reboots and hangs. I must use the repair setup.
Using a Gigabyte 7IX mobo (AMD Irongate).
Any ideas?
Thanks.
Try to get a new IDE drivers for w2k
Try to get new IDE drivers for w2k
OP
Hey thanks! Actually I never could find an AMD 756 IDE driver for win2k, and reading your post I went to AMD site and finally they have a busmaster win2k compatible driver v 1.32 dated August 2k...
Installed it and it runs fine in DMA mode now!
Thanks again
Installed it and it runs fine in DMA mode now!
Thanks again
