P3 1Ghz 100FSB on Abit BE6 II

This is a discussion about P3 1Ghz 100FSB on Abit BE6 II in the Windows Hardware category; Anyone tried or are considering using a P3 1Ghz with the 100 FSB SECCII on Abit's BE6II? I need to upgrade my P3 500 but I want it to be worth while. Any feedback with be very appreciated!.

Windows Hardware 9627 This topic was started by Dredd, 2001-04-26 16:16. Last reply by Frank_Black, 2001-04-27 16:41

Discussion 1

Dredd

120 Posts
Location -
Joined 2000-03-13

#47765

2001-04-26 18:16

Anyone tried or are considering using a P3 1Ghz with the 100 FSB SECCII on Abit's BE6II? I need to upgrade my P3 500 but I want it to be worth while. Any feedback with be very appreciated!

Post the IP's you ban on your proxy servers here!

anyone ever used a Multi-tech MT5634ZPX 56K Voice/Data/Fax

Participate in our website and join the conversation

You already have an account on our website? To log in, use the link provided below.

Create a new user account. Registration is free and takes only a few seconds.

This subject has been archived. New comments and votes cannot be submitted.

Apr 26

Created

Apr 27

Last Response

0

Likes

1 minute

Read Time

Users

Responses to this topic

Frank_Black

28 Posts
Location -
Joined 2000-10-31

#47766

2001-04-27 16:41

I upgraded from 500 to 800 mhz P!!! with a 100mhz front side bus and the upgrade increased the speed dramatically, I did this on an ABit bx6r2 board, which I think will only accept up to a 900mhz FSB chip, and that is all manual CPU tweaking, cause the board does not recognize anything over 700mhz, so I would check out abit's site and get the newest BIOS and see what processor that accepts, if not go to the abit newsgroups and ask around their to others who have your board.