ProphetDDR+EpoxKX133 == Reboot w/ 5.13 or >

This is a discussion about ProphetDDR+EpoxKX133 == Reboot w/ 5.13 or > in the Windows Hardware category; I'm still stuck with the 3. 78 driver set from with the 3. 66 NV4_mini. sys. So far, all the current drivers I've used have failed. They where unstable and crashed often after 5minutes. I tried the 5.

Windows Hardware 9627 This topic was started by psi, 2000-04-19 02:41. Last reply by psi, 2000-04-20 20:47

Discussion 2

psi

9 Posts
Location -
Joined 1999-08-25

#18319

2000-04-19 04:41

I'm still stuck with the 3.78 driver set from www.hercules.com with the 3.66 NV4_mini.sys. So far, all the current drivers I've used have failed. They where unstable and crashed often after 5minutes. I tried the 5.xx drivers. It would boot all the way up to the point where you see the win2k logo and the scrolling bar at the bottom. But when it refreshes into display driver I see my CD-Rom drive light flash and my rig reboots. I have to boot into VGA mode and go back to the 3.78/3.66 combo. Any advice? Could this be a MS registry error? Any one else having these problems with my setup?

Epox133/GeforceDDR Prophet/256pc100/athlon500

Thanks much -- psi

------------------

AGP not Supported???

Win 2k and V3 2k PCI Help

Participate in our website and join the conversation

You already have an account on our website? To log in, use the link provided below.

Create a new user account. Registration is free and takes only a few seconds.

This subject has been archived. New comments and votes cannot be submitted.

Apr 19

Created

Apr 20

Last Response

0

Likes

2 minutes

Read Time

Users

Responses to this topic

slkh

164 Posts
Location -
Joined 2000-01-15

#18320

2000-04-19 12:31

There is some problem with Epox motherboard if I am not mistaken. Check tomshardware Epox vs Asus guide

psi

9 Posts
Location -
Joined 1999-08-25

#18321

2000-04-20 20:47

Well, I set the CAS to auto and turned off SGRAM bank interleaving and I can finally boot into win2k with full AGP support and the 5.13 drivers. I tried using the 5.14 but just about when it goes to hit the display driver, I get a high pitch noise raging out of my sound card and into my 5.1 setup. Luckly it didn't blow the speakers and my cat was pissed. But at least I can finally boot with good drivers.

Thanks much man. -- psi

------------------
<><><><><><><><><><><><>
There are two major products that come out of Berkeley: LSD and SETI@home. I don't believe this to be a coincidence.
<><><><><><><><><><><><>