w2k freeze - not a BSOD
This is a discussion about w2k freeze - not a BSOD in the Windows Hardware category; I've installed a number of builds (from 1949 all the way up to 2128), and each installation has suffered from random freezes. The computer would just stop responding, mouse freezes, etc. I know w2k is still in development, but does anyone have any suggestions or hints on know conflicts that could be causing these f ...
I've installed a number of builds (from 1949 all the way up to 2128), and each installation has suffered from random freezes. The computer would just stop responding, mouse freezes, etc. I know w2k is still in development, but does anyone have any suggestions or hints on know conflicts that could be causing these freezes? I have a single P2-300 (Tyan Thunder 2 motherboard (dual, but not using the 2nd CPU slot ).
Thanks!
Thanks!
Participate in our website and join the conversation
This subject has been archived. New comments and votes cannot be submitted.
Sep 22
Sep 27
0
1 minute
Responses to this topic
Please everthing you got in your System
OP
p2-300
tyan thunder 2
128 MB ram
adaptec 7895 scsi
actually, i think i have fixed it. I was reading someone's else's post (concerning ACPI), and I forced the ACPI_Enable=0 (txtsetup.sif). Reinstalled, and I haven't had a freeze. It's only been 12 hours , but before, it would freeze after about 10-20 minutes of use.
tyan thunder 2
128 MB ram
adaptec 7895 scsi
actually, i think i have fixed it. I was reading someone's else's post (concerning ACPI), and I forced the ACPI_Enable=0 (txtsetup.sif). Reinstalled, and I haven't had a freeze. It's only been 12 hours , but before, it would freeze after about 10-20 minutes of use.
I have the same board but with two Pentium II 350 and ACPI runs fine (W2K RC2).
Have you checked the BIOS setup ?
Have you checked the BIOS setup ?
