Win2K Wont Detect My Second Printer Port

This is a discussion about Win2K Wont Detect My Second Printer Port in the Windows Hardware category; I have a Gigabyte 6BXC Rev 2 motherboard. When I use Windows 98/Me it detects both printer ports LPT1 and LPT2. But in Windows 2000 it will only detect the first printer port. What can I do to make Win2k to detect it.

Windows Hardware 9627 This topic was started by , . Last reply by ,


data/avatar/default/avatar18.webp

1 Posts
Location -
Joined 2000-06-28
I have a Gigabyte 6BXC Rev 2 motherboard. When I use Windows 98/Me it detects both printer ports LPT1 and LPT2. But in Windows 2000 it will only detect the first printer port.
 
What can I do to make Win2k to detect it.
 
Cheers
 
------------------
Bah!

Participate in our website and join the conversation

You already have an account on our website? To log in, use the link provided below.
Login
Create a new user account. Registration is free and takes only a few seconds.
Register
This subject has been archived. New comments and votes cannot be submitted.
Jun 28
Created
Jun 29
Last Response
0
Likes
1 minute
Read Time
User User
Users

Responses to this topic


data/avatar/default/avatar35.webp

56 Posts
Location -
Joined 1999-12-02
I had the same problem (but also under 98 and NT, because all the second printer ports are non-pnp ISA devices).
Simply set all the settings manually (maybe you will have to fiddle around with BIOS settings of the other on-board ports), and manually install a second LPT port at the 'Add new hardware' panel. (Or EPP / ECC Port, depends on what you set your card to).
 
Then you will have to enter the settings for it manually under hardware configuration panel, and voila, it will work.
Maybe you will have to try some different settings for IRQ, DMA or address, but if the port worked under 9x, it will do that under 2K , too.
 
Have fun
 
Llion
 
[This message has been edited by Llion (edited 29 June 2000).]