ZoSo
I'm getting this error when I close Outlook 2003.
The instructions at "0x05c8a9fe" referenced memory at "0x61c2128. The memory could not be "read".
Click on OK to terminate the program.
I ran memtest, just incase, and all RAM is fine.
Any ideas?
Thanks,
ZoSo
The instructions at "0x05c8a9fe" referenced memory at "0x61c2128. The memory could not be "read".
Click on OK to terminate the program.
I ran memtest, just incase, and all RAM is fine.
Any ideas?
Thanks,
ZoSo
Participate on our website and join the conversation
This topic is archived. New comments cannot be posted and votes cannot be cast.
Responses to this topic
ZoSo
OP
The only thing that runs with Outlook is my Anti-virus proggy, I disabled it and I still get the error.
No overclocking, tried BIOS defaults too, same results.
Also tried using the "Detect and Repair" built into office, no luck.
I think I might just try to uninstall and re-install Office.
No overclocking, tried BIOS defaults too, same results.
Also tried using the "Detect and Repair" built into office, no luck.
I think I might just try to uninstall and re-install Office.
ZoSo
OP
OK, I found the problem. It was Steganos Security Suite, I had just updated it. What it did I'm not exactly sure yet, I'm still looking in to it.
But I found it by reading this article found at the MS site.
But I found it by reading this article found at the MS site.
Wicked101
Instead of re-installing you can do the following, it works even better than a re-install.
Start > Run > type in REGEDIT and click ok.
Follow this path on the left
HKEY_CURRENT_USER\Software\Microsoft\Office\11.0
Then delete the whole "Outlook" folder (still on the left)
Restart your PC and open Outlook, it will ask you to enter your settings and so on like it was a new installation.
Start > Run > type in REGEDIT and click ok.
Follow this path on the left
HKEY_CURRENT_USER\Software\Microsoft\Office\11.0
Then delete the whole "Outlook" folder (still on the left)
Restart your PC and open Outlook, it will ask you to enter your settings and so on like it was a new installation.
surgy
hey guys,
I was having the same problem but it seems to be fixed now! Just received an email from the very friendly steganos support and they told me that there is an update available on there web site.
I hope I could help you!
Bye,
Surgy
I was having the same problem but it seems to be fixed now! Just received an email from the very friendly steganos support and they told me that there is an update available on there web site.
I hope I could help you!
Bye,
Surgy
